Red

PLA Lite

Bambu Lab · PLA · Red

PLA

1.4 g/cm³ · ±0.03 mm · OFD 2026-07-11

Nozzle
205°C
190°tune within range220°
Bed
55°C
50°tune within range60°

Before you print

1 thing to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 65°C first, then keep it sealed.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PLA range. Confirm them on your first print. View Bambu Lab's datasheet →

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
1 kg
Density
1.4 g/cm³
Diameter tolerance
±0.03 mm
Available colors (1)
Red
#FF0000
Sources & verification