PETG

Proteor Print · PETG · Clear

PETG

1.27 g/cm³ · ±0.1 mm · OFD 2026-08-25

Nozzle

240 °C

230°tune within range250°

Bed

78 °C

70°tune within range85°

Before you print

1 thing to know about this spool

Dry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 65°C for about 4-6 hours first, then keep it sealed.
65 °C~4-6 h

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PETG range. Confirm them on your first print. View Proteor Print's datasheet →

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained database this catalog is built on.

Grab a spool

Also at Proteor Print.

Find on Amazon

Other retailers

Proteor PrintShips from US

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Print profile

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

Bambu Studio.json OrcaSlicer.json PrusaSlicer.ini Cura.xml.fdm_material

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Download the .ini file.
File → Import → Import Config Bundle.
Select the filament preset it adds.

Cura

Download the material file.
Preferences → Materials → Import.
Choose it as your material.

Temperatures are the typical PETG range (not filament-specific) — the file says so too. Confirm on your first print.

Bambu Studio and OrcaSlicer store a separate bed temperature for each build plate. This profile sets the Textured PEI and High Temp plates; on a Cool Plate, Cool Plate SuperTack or Engineering Plate your slicer keeps its own built-in value.