PVA PolySupport for PA12

Polymaker · PVA · Natural

PVA

1.29 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle

205°C

190°tune within range220°

Bed

55°C

45°tune within range65°

Before you print

1 thing to know about this spool

Dry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it first, then keep it sealed.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PVA range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Also at PolyMaker.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Other retailers

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures are the typical PVA range (not filament-specific) — the file says so too. Confirm on your first print.

Available colors (1)

Natural

#ACE063

Sources & verification