White

Support for ABS

Bambu Lab · PVA · White

PVA

1.16 g/cm³ · ±0.05 mm · OFD 2026-07-12

Nozzle
205°C
190°tune within range220°
Bed
55°C
45°tune within range65°

Before you print

1 thing to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it first, then keep it sealed.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PVA range. Confirm them on your first print. View Bambu Lab's datasheet →

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
500 g
Density
1.16 g/cm³
Diameter tolerance
±0.05 mm
Available colors (1)
White
#FFFFFF
Sources & verification