Nozzle
240°C
190°tune within range270°
From https://www.esun3d.com/epla-lw-product/
Bed
53°C
45°tune within range60°
From https://www.esun3d.com/epla-lw-product/
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 1 kg
- Density
- 1.21 g/cm³
- Diameter tolerance
- ±0.03 mm
Available colors (2)
Black
#090909
Editorial notesUpdated 2026-07-10
This foaming lightweight PLA changes density with temperature — print a temp tower first. eSUN warns PTFE-lined hotends shouldn't sit above 250 °C.
Made for RC planes and props: at ~240 °C it foams to roughly half density. Not a strength material — use it where grams matter.
Sources & verification
- Data: Open Filament Database
- OFD snapshot generated: 2026-07-12