White

Support for PLA

Bambu Lab · PVA · White

PVA

1.33 g/cm³ · ±0.05 mm · OFD 2026-07-12

Nozzle
225°C
220°tune within range230°
From Bambu Lab Support for PLA TDS V1.0 (store.bambulab.com)
Bed
40°C
35°tune within range45°
From Bambu Lab Support for PLA TDS V1.0 (store.bambulab.com)

Before you print

1 thing to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 55°C first, then keep it sealed.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
500 g
Density
1.33 g/cm³
Diameter tolerance
±0.05 mm
Available colors (1)
White
#FFFFFF
Editorial notesUpdated 2026-07-10

Despite the PVA label in the database, this is Bambu's peel-off (break-away) support — it is NOT water-soluble. Bambu sells actual PVA separately.

Sources & verification