Nozzle
230 °C
220°tune within range240°
Bed
50 °C
35°tune within range65°
Before you print
1 thing to know about this spoolDry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 40-45°C for about 4-6 hours first, then keep it sealed.
40-45 °C~4-6 h
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained database this catalog is built on.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 500 g
- Density
- 1.25 g/cm³
Available colors (1)
Natural
#EFF4A4
Sources & verification
- Data: spotted by SpoolBites on Anycubic PVA product page specification table (store.anycubic.com) on 2026-08-31 (community database submission in progress)
- Temperatures: Anycubic PVA product page specification table (Printing Temperature, Heated Bed Temperature)