Beige

PETG

Anycubic · PETG · Beige

PETG
21 colors

1.23 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle
235°C
220°tune within range250°
Bed
78°C
70°tune within range85°

Before you print

1 thing to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 65°C first, then keep it sealed.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PETG range. Confirm them on your first print. View Anycubic's datasheet →

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
1 kg
Density
1.23 g/cm³
Diameter tolerance
±0.02 mm
Available colors (21)
Beige
#D4B996
Sources & verification