Black

rABS

Add-North · ABS · Black

ABS

1.03 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle
245°C
230°tune within range260°
Bed
100°C
90°tune within range110°

Before you print

3 things to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 65°C first, then keep it sealed.

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

  • Give it plenty of fresh air

    It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical ABS range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
750 g
Density
1.03 g/cm³
Diameter tolerance
±0.02 mm
Available colors (1)
Black
#000000
Sources & verification