In the Dark

Glow ABS

Hatchbox · ABS · In the Dark

ABS

1.04 g/cm³ · ±0.02 mm · OFD 2026-07-11

Nozzle
245°C
230°tune within range260°
Bed
100°C
90°tune within range110°

Before you print

3 things to know about this spool

  • Fit a hardened-steel nozzle

    What is mixed into this filament — fiber or glow pigment — grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

  • Give it plenty of fresh air

    It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
1 kg
Density
1.04 g/cm³
Diameter tolerance
±0.02 mm
Available colors (1)
In the Dark
#3D9441
Sources & verification