Nozzle
205°C
190°tune within range220°
Bed
55°C
50°tune within range60°
Before you print
1 thing to know about this spoolDry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 50°C first, then keep it sealed.
Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PLA range. Confirm them on your first print. View Add-North's datasheet →
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 750 g / 2.3 kg
- Density
- 1.24 g/cm³
- Diameter tolerance
- ±0.02 mm
Available colors (2)
Black
#000000
Sources & verification
- Data: Open Filament Database
- Manufacturer datasheet: https://storage.googleapis.com/addnorth-com.appspot.com/imgix/assets/production/TDS_htplapromatte_-qP4pe.pdf
- Safety datasheet: https://storage.googleapis.com/addnorth-com.appspot.com/imgix/assets/production/MSDS_HTPLA_W-_Rjk.pdf
- OFD snapshot generated: 2026-07-12