PET CoPE

Panchroma · PET · Aqua Blue

PET

1.3 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle

245°C

230°tune within range260°

Bed

73°C

60°tune within range85°

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PET range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Grab a spool

Also at PolyMaker.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Other retailers

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

OrcaSlicer already includes this filament. Pick “Panchroma CoPE” in its filament list — the built-in profile is tuned even further than ours.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures are the typical PET range (not filament-specific) — the file says so too. Confirm on your first print.

Available colors (27)

Aqua Blue

#5FBCDD

+ 3 more colors

Sources & verification