Nozzle
275 °C
260°tune within range290°
Bed
90 °C
80°tune within range100°
Before you print
2 things to know about this spoolFit a hardened-steel nozzle
The stuff mixed into this filament (fiber or glow pigment) grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.
Dry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 60-70°C for about 4-6 hours first, then keep it sealed.
60-70 °C~4-6 h
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained database this catalog is built on.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 500 g
- Density
- 1.3 g/cm³
Available colors (1)
Black
#212322
Sources & verification
- Data: spotted by SpoolBites on Anycubic PET-CF product page and Technical Data Sheet V3.0 (store.anycubic.com) on 2026-08-06 (community database submission in progress)
- Temperatures: Anycubic PET-CF Technical Data Sheet V3.0 (recommended printing parameters, 0.4 mm nozzle)