Marble Gray

ABS Art Marble Gray

Nebula · ABS · Marble Gray

ABS

1.04 g/cm³ · ±0.03 mm · OFD 2026-07-12

Nozzle
245°C
230°tune within range260°
Bed
100°C
90°tune within range110°

Before you print

2 things to know about this spool

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

  • Give it plenty of fresh air

    It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical ABS range. Confirm them on your first print. View Nebula's datasheet →

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm / 2.85 mm
Spool sizes
500 g – 9 kg
Density
1.04 g/cm³
Diameter tolerance
±0.03 mm
Available colors (1)
Marble Gray
#D0D8DA
Sources & verification