ASA Extrafill

Fillamentum · ASA · Anthracite Grey

ASA

1.07 g/cm³ · ±0.05 mm · OFD 2026-07-12

Nozzle

248°C

240°tune within range255°

Bed

93°C

80°tune within range105°

Before you print

2 things to know about this spool

Print inside an enclosure
It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.
Give it plenty of fresh air
It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Check current pricing for Fillamentum ASA Extrafill.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures from the Open Filament Database, baked into the file with a source note.

Available colors (15)

Anthracite Grey

#293133

Sources & verification