Natural

Vulcan Pi TPI

Tectonic 3D · TPI · Natural

TPI

1.24 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle
Not in OFD
Check manufacturer datasheet
Bed
Not in OFD
Check manufacturer datasheet

Before you print

2 things to know about this spool

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

  • Needs a high-temperature hotend

    It runs hotter than everyday filaments. Check your printer can reach its nozzle temperature before you buy.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
1 kg
Density
1.24 g/cm³
Diameter tolerance
±0.02 mm
Available colors (1)
Natural
#DFDFD3
Sources & verification