Baby Blue

EVA+

Proteor Print · EVA · Baby Blue

EVA
4 colors

0.92 g/cm³ · ±0.1 mm · OFD 2026-07-12

Nozzle
Not in OFD
Check manufacturer datasheet
Bed
Not in OFD
Check manufacturer datasheet

Before you print

1 thing to know about this spool

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 55°C first, then keep it sealed.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Temperatures aren't yet in our database. View Proteor Print's technical datasheet →

Specs

Diameter
2.85 mm
Spool sizes
4.3 kg
Density
0.92 g/cm³
Diameter tolerance
±0.1 mm
Available colors (4)
Baby Blue
#00AAFF
Sources & verification