Nozzle
280°C
260°tune within range300°
Bed
110°C
100°tune within range120°
Before you print
3 things to know about this spoolDry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it first, then keep it sealed.
Print inside an enclosure
It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.
Give it plenty of fresh air
It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 1 kg
- Density
- 1.2 g/cm³
- Diameter tolerance
- ±0.02 mm
Available colors (2)
Black
#000000
Sources & verification
- Data: Open Filament Database
- OFD snapshot generated: 2026-07-11