LUVOCOM 3F PEEK CF 9676

FormFutura · PEEK · Black

PEEK

1.34 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle

425°C

400°tune within range450°

Bed

140°C

120°tune within range160°

Before you print

4 things to know about this spool

Fit a hardened-steel nozzle
What is mixed into this filament — fiber or glow pigment — grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.
Dry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it first, then keep it sealed.
Print inside an enclosure
It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.
Needs a high-temperature hotend
It runs hotter than everyday filaments. Check your printer can reach its nozzle temperature before you buy.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Also at FormFutura.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Other retailers

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures from the Open Filament Database, baked into the file with a source note.

Available colors (1)

Black

#000000

Sources & verification