Nozzle
Not in OFD
Check manufacturer datasheet
Bed
Not in OFD
Check manufacturer datasheet
Before you print
1 thing to know about this spoolGive it plenty of fresh air
It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 1 kg
- Density
- 1.24 g/cm³
- Diameter tolerance
- ±0.02 mm
Available colors (2)
"Black"
#000000
Sources & verification
- Data: Open Filament Database
- OFD snapshot generated: 2026-07-12