Grey

PPS-GF20

Fiberon · PPS · Grey

PPS

1.36 g/cm³ · ±0.03 mm · OFD 2026-07-12

Nozzle
315°C
300°tune within range330°
Bed
120°C
100°tune within range140°

Before you print

3 things to know about this spool

  • Fit a hardened-steel nozzle

    What is mixed into this filament — fiber or glow pigment — grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

  • Needs a high-temperature hotend

    It runs hotter than everyday filaments. Check your printer can reach its nozzle temperature before you buy.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PPS range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
500 g / 3 kg
Density
1.36 g/cm³
Diameter tolerance
±0.03 mm
Available colors (1)
Grey
#615D5C
Sources & verification