Nozzle
270 °C
260°tune within range280°
Bed
115 °C
110°tune within range120°
Before you print
1 thing to know about this spoolDry it before you print
It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it at 60-70°C for about 4-6 hours first, then keep it sealed.
60-70 °C~4-6 h
New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
- Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
- Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
- OFD is the Open Filament Database, the community-maintained database this catalog is built on.
Specs
- Diameter
- 1.75 mm
- Spool sizes
- 750 g
- Density
- 1.18 g/cm³
- Diameter tolerance
- ±0.02 mm
Available colors (1)
Pure Transparent
#F2F2F2
Sources & verification
- Data: Open Filament Database
- Temperatures: Fiberlogy print settings (np3dp.com, spot-checked vs Fiberlogy TDS)
- OFD snapshot generated: 2026-08-25