PP-CF

Eryone · PP · Black

0.95 g/cm³ · ±0.03 mm · OFD 2026-07-12

Nozzle

230°C

215°tune within range245°

Bed

93°C

85°tune within range100°

Before you print

2 things to know about this spool

Fit a hardened-steel nozzle
What is mixed into this filament — fiber or glow pigment — grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.
Print inside an enclosure
It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PP range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Also at Eryone.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Other retailers

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

OrcaSlicer already includes this filament. Pick “Eryone PP-CF” in its filament list — the built-in profile is tuned even further than ours.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures are the typical PP range (not filament-specific) — the file says so too. Confirm on your first print.

Available colors (1)

Black

#171319

Sources & verification