Black

PA6 Carbonfiber nylon

AzureFilm · PA6 · Black

PA6

1.08 g/cm³ · ±0.02 mm · OFD 2026-07-11

Nozzle
265°C
250°tune within range280°
Bed
95°C
80°tune within range110°

Before you print

3 things to know about this spool

  • Fit a hardened-steel nozzle

    What is mixed into this filament — fiber or glow pigment — grinds down a soft brass nozzle fast. A hardened-steel one stands up to it.

  • Dry it before you print

    It quietly soaks up moisture from the air, which leaves prints rough, weak and stringy. Dry it first, then keep it sealed.

  • Print inside an enclosure

    It cools too fast in open air and can warp or crack. A closed-in printer holds the heat around the print.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PA6 range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.
  • Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
  • Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
  • OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Specs

Diameter
1.75 mm
Spool sizes
500 g
Density
1.08 g/cm³
Diameter tolerance
±0.02 mm
Available colors (1)
Black
#000000
Sources & verification