PVDF

Add-North · PVDF · Adamant S1 White

PVDF

1.24 g/cm³ · ±0.02 mm · OFD 2026-07-12

Nozzle

255°C

240°tune within range270°

Bed

100°C

90°tune within range110°

Before you print

1 thing to know about this spool

Give it plenty of fresh air
It gives off fumes as it prints. Run it in a well-ventilated room or a filtered enclosure, not a closed bedroom.

Manufacturer didn't publish exact temps for this filament. The numbers above are the typical PVDF range. Confirm them on your first print.

New here? Nozzle = printing temperature in your slicer, bed = build plate. Start at the big number.

Nozzle is the hot-end temperature: enter it as the printing temperature in your slicer. Start at the big number; the range is the safe window to tune within.
Bed is the heated build plate: your slicer calls it bed temperature. It helps prints stick.
OFD is the Open Filament Database, the community-maintained source this spec sheet comes from.

Check current pricing for Add-North PVDF.

As an Amazon Associate, SpoolBites earns from qualifying purchases.

Free downloadable print profile

Sets this spool's temperatures, material and specs in your slicer. Everything else stays at your slicer's own defaults.

How do I install this? 3 steps per slicer

Bambu Studio / OrcaSlicer

Download the file above.
Open the slicer, click the filament dropdown, choose Import (or drag the file into the window).
Pick the “(SpoolBites)” entry from your filament list.

PrusaSlicer

Cura

Temperatures are the typical PVDF range (not filament-specific) — the file says so too. Confirm on your first print.

Available colors (1)

Adamant S1 White

#FFFFFF

Sources & verification